A client in Ubi Techpark wanted the electrical circuits in a newly acquired office and warehouse separated so the spaces could be rented to two different tenants. The premises also had several defects requiring rectification, including bad wiring, blown light bulbs, burnt starters, and short-circuited ballasts. GC Werkz assisted by installing an electrical sub-meter, isolating and rewiring faulty wires, replacing legacy fluorescent tube systems, and checking the client’s telecommunications, IT, and appliances. Additional work included adding supplementary locks.
Project example
Office and Warehouse Electrical Circuit Separation at Ubi Techpark
A client in Ubi Techpark wanted the electrical circuits in a newly acquired office and warehouse separated so the spaces could be rented to two different tenants. The premises also had several defects requiring rectification, including bad wiring, blown light bulbs, burnt starters, and short-circuited ballasts. GC Werkz assisted by installing an electrical sub-meter, isolating and rewiring faulty wires, replacing legacy fluorescent tube systems, and checking the client’s telecommunications, IT, and appliances. Additional work included adding supplementary locks.
Work summary
What was done
The details below summarise the reported issue, confirmed finding, work scope and completed outcome.
The office and warehouse circuits needed to be separated for two-tenant rental use. The premises also had electrical defects including bad wiring, blown bulbs, burnt starters, and short-circuited ballasts.
The documented defects included bad wiring, blown light bulbs, burnt starters, and short-circuited ballasts.
Separate electrical circuits between office and warehouse areas
Install electrical sub-meter
Isolate faulty wires
Rewire faulty wiring
Replace blown light bulbs
Replace burnt starters
Replace short-circuited ballasts
Swap out legacy fluorescent tube systems
Check telecommunications setup
Check IT-related points or equipment
Check appliances
Add supplementary locks
The work was carried out as a commercial defect rectification and circuit separation scope for a newly acquired office and warehouse. GC Werkz addressed the electrical separation requirement first by installing a sub-meter and separating the circuits, then rectified faulty wiring and lighting-related defects before carrying out checks on telecommunications, IT, and appliances. Supplementary locks were added as part of the additional work.
The office and warehouse electrical circuits were separated to support rental to two different tenants. The documented wiring and lighting defects were rectified, and supplementary locks were added.
Project photos
Before and after photos.
Project FAQ
Common questions about this project.
Why did the client need electrical circuit separation at Ubi Techpark?
The client wanted the circuits in the newly acquired office and warehouse separated so the spaces could be rented to two different tenants.
What electrical defects were found?
The notes list bad wiring, blown light bulbs, burnt starters, and short-circuited ballasts.
What electrical work did GC Werkz carry out?
GC Werkz installed an electrical sub-meter, isolated and rewired faulty wires, replaced defective lighting components, and swapped out legacy fluorescent tube systems.
Did the work include non-electrical checks?
Yes. The notes state that GC Werkz checked through the client’s telecommunications, IT, and appliances.
Was additional security-related work included?
Yes. Additional work included adding supplementary locks.
Need help with a similar scope?
Send the work details for review.
Share photos, property type, access notes and preferred timing so GC Werkz can review your enquiry and suggest the next practical step.